Welcome![Sign In][Sign Up]
Location:
Search - temperature cpu

Search list

[CSharpGetCoreTempInfo

Description: 嗯,这个吗,这是其中一个用来获取CPU的温度的头文件-a head file ,which used to get the temperature of CPU
Platform: | Size: 1024 | Author: CSDQ | Hits:

[Delphi VCLTempmonitor

Description: 用Delphi编写的一个小程序,用来检测CPU及硬盘的温度,同时它还可以检测出电脑运行了多少时间,不过好像温度作者忘记换算了吧?偶的CPU温度竟然达到6万多度,硬盘也是253度,这也太离谱了吧? -Written with Delphi, a small program used to detect the temperature of CPU and hard drive, while it can detect how much time the computer is running, but seems to forget that the temperature of conversion, right? Even the CPU temperature has reached more than 60,000 degrees, the hard disk is 253 degrees, it is quite weird, right?
Platform: | Size: 738304 | Author: 天行健 | Hits:

[Otheropenhardwaremonitor

Description: open hardware monitor源码,测试CPU等硬件温度-open hardware monitor source code, test CPU hardware temperature
Platform: | Size: 2803712 | Author: zjjne | Hits:

[Windows DevelopDht11

Description: 采用单总线方式与cpu进行数据传输,与DS18B20相似,对时序的要求比较高,不同之处在于写程序的时候数据的采集必须间隔1s以上,不然采集会失败。此篇将利用arduino驱动DHT11,检测环境温湿度情况。-The cpu data transfer using a single bus with DS18B20 similar timing requirements are relatively high, the difference lies in the writing program data collection must be spaced more than 1s, or collected will fail. This case the use of arduino driven DHT11, detection of environmental temperature and humidity.
Platform: | Size: 3072 | Author: zang | Hits:

[OS programCPUaHDD_Temperature

Description: 利用WINDOWS平台中的WMI函数获取CPU和硬盘的温度-CPU&HDD Temperature
Platform: | Size: 21504 | Author: lee | Hits:

[SCMDS18B20

Description: DS18B20控制方法 DS18B20有六条控制命令,如表4.1所示: 表4.1 为DS18B20有六条控制命令 指 令 约定代码 操 作 说 明 温度转换 44H 启动DS18B20进行温度转换 读暂存器 BEH 读暂存器9位二进制数字 写暂存器 4EH 将数据写入暂存器的TH、TL字节 复制暂存器 48H 把暂存器的TH、TL字节写到E2RAM中 重新调E2RAM B8H 把E2RAM中的TH、TL字节写到暂存器TH、TL字节 读电源供电方式 B4H 启动DS18B20发送电源供电方式的信号给主CPU -DS18B20 control method DS18B20 six control commands, as shown in Table 4.1: Table 4.1 DS18B20 six control commands instructions convention code instructions the temperature conversion 44H start DS18B20 temperature conversion Read Scratchpad the BEH read register 9 binary digits writethe register 4EH the data written to the scratchpad TH, TL-byte copy registers 48H to register TH the the TL byte write E2RAM in re-tune the TH E2RAM B8H the E2RAM, TL byte writeto scratchpad TH, TL-byte read supply way B4H start DS18B20 send supply a signal to the main CPU
Platform: | Size: 43008 | Author: 王永存 | Hits:

[Linux-Unixvia-cputemp

Description: linux device Driver for VIA CPU core temperature monitoring-linux device Driver for VIA CPU core temperature monitoring
Platform: | Size: 2048 | Author: jonsington | Hits:

[OtherCkeckTemperature

Description: DOS下读写CPU,系统温度的C语言程序,superI/O为F818-a C program of checking temperature superI/O F81866
Platform: | Size: 1024 | Author: akun | Hits:

[Dialog_WindowVB-cpu_temp

Description: VB 通过控件获取CPU温度 并且实时显示到界面-VB controls access to the CPU temperature and through the real-time display to the interface
Platform: | Size: 5120 | Author: yinnianlong | Hits:

[Windows Developmobmeter

Description: 一个电脑CPU性能和温度检测小工具,很方便实用,直接打开即在桌面显示,CPU的性能和温度。-A computer CPU performance and temperature detection of small tools, very convenient and practical, that is directly open the desktop display, CPU performance and temperature.
Platform: | Size: 36864 | Author: ndpoi | Hits:

[Windows Developmobmeter

Description: 一个电脑CPU性能和温度检测小工具,很方便实用,直接打开即在桌面显示,CPU的性能和温度。-A computer CPU performance and temperature detection of small tools, very convenient and practical, that is directly open the desktop display, CPU performance and temperature.
Platform: | Size: 36864 | Author: efingIt | Hits:

[SCMDHT11

Description: 该测控系统是以单片机为核心,配合sht11温湿度传感器,以及相关的光耦电路组成。可以接收和控制所测环境的温度和湿度。该装置的工作原理是由温湿度传感器得到测量信号,经电路转换为电信号,然后送到单片机进行数据处理,经软件分析处理后送显示装置,CPU根据检测到的温度和湿度结果,判断温度,湿度是否在界定的范围内,由此启动控制装置,并进行自动调节,直到温度和湿度达到标准范围之内为止。-The control system is a microcontroller as the core, with sht11 temperature and humidity sensors, as well as related optocoupler circuits. Can receive and control of environmental temperature and humidity measured. The working principle of the device is to be measured by the temperature and humidity sensor signal is converted to an electrical signal via the circuit, and then sent to microcontroller for data processing, analysis and processing by software evacuation display device, CPU based on the detected results of the temperature and humidity, judgment temperature , humidity within the defined range, thereby activating the control device and automatically adjust until the temperature and humidity within the range of up to standard so far.
Platform: | Size: 811008 | Author: admin | Hits:

[Windows Develop564758665

Description: VB通过 MSAcpi 检测CPU温度,有需要的就下载吧。-VB through MSAcpi detect CPU temperature, there is a need to download it.
Platform: | Size: 2048 | Author: 烟鸭掌儿 | Hits:

[Other Embeded programmsp430g2xx3_uscib0_i2c_01

Description: I2C接口TMP100温度传感器在9位模式。 计时器一CCR0中断用于醒来,读这两个字节的 TMP100的温度寄存器每62毫秒。如果温度大于28 c,p1 0设置,否则复位。在LPM0 CPU操作。 速度~ 100 khz I2C。-I2C interface to TMP100 temperature sensor in 9-bit mode. Timer_A CCR0 interrupt is used to wake up and read the two bytes of the TMP100 temperature register every 62ms. If the temperature is greater than 28C, P1.0 is set, else reset. CPU is operated in LPM0. I2C speed is ~100kHz.
Platform: | Size: 2048 | Author: 马保 | Hits:

[OS program5

Description: 易语言写的 cpu温度检测 与360有的一拼-Written in easy language cpu temperature sensing a fight with the 360
Platform: | Size: 51200 | Author: guoke | Hits:

[SCMDS18B20

Description: DS18B20测温程序,控制DS18B20完成一次温度转换定时器A的计数时钟是1MHz,CPU主频8MHz 所以通过定时器延时能够得到极为精确的 us级延时-DS18B20 measurement procedures, control DS18B20 temperature conversion to complete a timer A count clock is 1MHz, CPU clocked at 8MHz so by timer delay can be extremely precise level delay us
Platform: | Size: 1024 | Author: 付婕 | Hits:

[Embeded-SCM Developc8051f040-ad

Description: C8051F040的AD转换程序,检测CPU的温度并实时显示-C8051F040 the AD conversion process to detect the temperature of CPU and real-time display
Platform: | Size: 8192 | Author: oeconom | Hits:

[uCOSSUN

Description: 基于UC/OS-II的温度实时监测系统, 控制CPU自带温度传感器,并将温度显示在数码管或LCD上;当温度大于设定值时报警;报警驱动蜂鸣器并通过串口上传到PC;PC给出消除报警指令后则取消报警;报警的重新启动由按键通过中断送入;合理安排UC/OS-II实时任务,合理利用UC/OS-II各类事件机制(信号量、消息邮箱、消息队列、事件标志组等)。-Based on UC/OS-II real-time temperature monitoring system, the control CPU comes with a temperature sensor and the temperature on the digital display or LCD when the temperature is greater than the set value alarm alarm buzzer driver and uploaded to the PC via the serial port the PC gives instructions to eliminate warning alarm is canceled restart interrupted by an alarm from the key into reasonable arrangements for UC/OS-II real-time tasks, rational use of UC/OS-II mechanism for all types of events (semaphores, message mailboxes , message queues, event flag groups, etc.).
Platform: | Size: 609280 | Author: iachi | Hits:

[androidCPUTest

Description: 根据机器提供的资讯,读取目前的Android系统中,计算机的CPU的温度-According to information provided by the machine reads the current Android system, the computer' s CPU temperature
Platform: | Size: 1440768 | Author: 柯猴猴 | Hits:

[SCMA7108

Description: CPU为STC12C5608AD, 实现对无线IC A7108的读写操作,实现短距离无线通信,采集温度。-CPU is STC12C5608AD, realize the wireless IC A7108 read and write operations to achieve short-distance wireless communication, collecting temperature.
Platform: | Size: 160768 | Author: 邹小龙 | Hits:
« 1 2 3 4 5 6 78 9 »

CodeBus www.codebus.net